Although fluoride is beneficial for human beings in small quantities, it causes dental fluorosis when consumed in larger quantities over a period of time. In recent years, considerable work has been conducted for the purpose of developing new and low cost absorbents for adsorptive removal of fluoride, especially chelating resins loaded with metal ions. In the present study, several types of adsorbents with different functional groups loaded with lanthanum(III) were prepared to be used for fluoride removal from water. The optimum conditions for loading lanthanum(III) on the adsorbents and the effects of pH and initial fluoride concentration as well as shaking time and solid-liquid ratio on the removal of fluoride have been investigated. Based on these fundamental data, the removal of fluoride from actual hot spring water was also tested as a practical application by comparing the efficiency of different adsorbents for the removal of fluoride from hot spring water. The following conclusions were obtained. (1) The different chemical composition and chemical structure of the polymer matrix play the most important role in fluoride adsorption, (2) strongly acidic adsorbents are more effective on fluoride removal at neutral pH than weakly acidic adsorbents, (3) the order of fluoride removal in the neutral pH range of 4.5-8.0 by the different La(III)-loaded adsorbents employed in the present work is as follows: 200CT resin > POJRgel > IR124 resin > SOJR gel > CPA gel > WK11 resin. The column experiments showed that the 200CT resin loaded with lanthanum(III) at pH 6.0 can be successfully employed for the removal of fluoride ions from actual hot spring water. (C) 2003 Society of Chemical Industry.