A theoretical study on a tubular membrane reactor assuming isothermal operation, plug flow pattern and using a dense polymeric catalytic membrane is performed. The reactor conversion for an equilibrium gas-phase reaction generically represented by A B is analyzed, considering the influence of the product's sorption and diffusion coefficients. It is concluded that the conversion of such a reaction can be significantly improved when the overall diffusion coefficient of the reaction product is higher than the reactant's one and/or the overall sorption coefficient is lower, and for Thiele modulus and contact time values over a threshold. Though a sorption coefficient of the reaction product lower than that of the reactant may leads to a conversion enhancement higher than that one obtained when the reaction product diffusion coefficient is. higher than that of the reactant, the contact time value for the maximum conversion is much higher in the first case. In this way, a higher diffusion coefficient for the reaction product should be generally preferable, because it leads to a lower reactor size. The performance of a dense polymeric catalytic membrane reactor depends in a different way on both sorption and diffusion coefficients of reactants and products and then a study of such a system cannot be based only on their own permeabilities. Favorable combinations of diffusion and sorption coefficients can affect positively the reactor's conversion. (C) 2003 Elsevier B.V. All rights reserved.