Differential scanning calorimetry (DSC) and temperature modulated DSC (MTDSC) have been used to investigate the melting behaviour of poly(ethylene terephthalate) (PET). Multiple melting endotherms were observed even at high heating rates, e.g. 160 K min(-1) and these have been attributed to the presence of two different distributions of lamella thickness and re-crystallisation (reorganisation) on heating. This has been confirmed by MTDSC-the presence of endotherms and an exotherm in the reversing component of the heat flow during heating. Examination of the endotherms of samples heating stepwise indicated that further crystallisation took place above the isothermal crystallisation temperature (T-c). Some part of this was associated with lamella thickening and crystal perfecting. The multiple melting endotherms observed are a consequence of the balance between the melting and re-crystallisation and the lamella thickness distribution existing within the sample, prior to heating. The triple melting endotherms observed are attributed to the melting of secondary and primary lamellae produced on crystallisation and to thickened lamellae produced during heating to the melting point.