We now report the molecular and crystal structure design of muconic ester derivatives on the basis of crystal engineering using halogen-halogen contacts and CH/pi. interactions. The solid-state photoreaction pathway of the dibenzyl (Z,Z)-muconates as the 1,3-diene dicarboxylic acid monomers depends on the structure of the ester groups. The substitution of a halogen atom for the aromatic hydrogen of a benzyl group induces topochemical polymerization to produce stereoregular polymers in a crystalline form, whereas the unsubstituted benzyl derivative isomerizes to yield the corresponding E, E isomer under similar conditions. The topochemical polymerization process is directly confirmed by the fact that the single-crystal structures before and after the polymerization are very similar to each other. From the crystal structure analysis for a series of substituted benzyl (Z,Z)-and (E,E)-muconates, it has been revealed that the planar diene moieties are closely packed to form a columnar structure in the crystals. The stacking of the polymerizable monomers is characterized by a stacking distance of 4.9-5.2 Angstrom along the columns. This structure is supported by a halogen-halogen interaction between the chlorine or bromine atoms introduced at the p position of the benzyl groups in addition to an aromatic stacking due to the CH/pi interaction between the benzylic methylene hydrogens and aromatic rings. The design of a monomer packing corresponds to the type and position of the introduced halogen atom and also the polymorphs. To make a stacking distance of 5 Angstrom using both halogen-halogen and CH/pi interactions as supramolecular synthons is important for the molecular design of muconic ester derivatives appropriate for topochemical polymerization.