화학공학소재연구정보센터
Journal of the American Chemical Society, Vol.124, No.22, 6367-6377, 2002
Fine-tuning of copper(I)-dioxygen reactivity by 2-(2-pyridyl)ethylamine bidentate ligands
Copper(l)-dioxygen reactivity has been examined using a series of 2-(2-pyridyl)ethylamine bidentate ligands (R1)Py1(R2.R3). The bidentate ligand with the methyl substituent on the pyridine nucleus (Me)Py1(Et,Bz) (N-benzyl-N-ethyl-2-(6-methylpyridin-2-yl)ethylamine) predominantly provided a (mu-eta(2):eta(2)-peroxo)dicopper(II) complex, while the bidentate ligand without the 6-methyl group (H)Py1(Et,Bz) (N-benzyl-N-ethyl-2(2-pyridyl)ethylamine) afforded a bis(mu-oxo)dicopper(lII) complex under the same experimental conditions. Both Cu2O2 complexes gradually decompose, leading to oxidative N-dealkylation reaction of the benzyl group. Detailed kinetic analysis has revealed that the bis (mu-oxo)dicopper(III) complex is the common reactive intermediate in both cases and that O-O bond homolysis of the peroxo complex is the rate-determining step in the former case with (Me)Py1(Et,Bz). On the other hand, the copper([) complex supported by the bidentate ligand with the smallest N-alkyl group ((H)Py1(Me,Me), N,N-dimethyl-2-(2-pyridyl)ethylamine) reacts with molecular oxygen in a 3:1 ratio in acetone at a low temperature to give a mixed-valence trinuclear copper(II, II, III) complex with two mu(3)-oxo bridges, the UV-vis spectrum of which is very close to that of an active oxygen intermediate of lacase. Detailed spectroscopic analysis on the oxygenation reaction at different concentrations has indicated that a bis(mu-oxo)dicopper(III) complex is the precursor for the formation of trinuclear copper complex. In the reaction with 2,4-di-tert-butylphenol (DBP), the trinuclear copper(II, II, III) complex acts as a two-electron oxidant to produce an equimolar amount of the C-C coupling dimer of DBP (3,5,3',5-tetra-tert-butyl - biphenyl-2,2'-diol) and a bis(mu-hydroxo)dicopper(II) complex. Kinetic analysis has shown that the reaction consists of two distinct steps, where the first step involves a binding of DBP to the trinuclear complex to give a certain intermediate that further reacts with the second molecule of DBP to give another intermediate, from which the final products are released. Steric and/or electronic effects of the 6-methyl group and the N-alkyl substituents of the bidentate ligands on the copper(I)-dioxygen reactivity have been discussed.