Metallocene polyethylene (mPE) fractions are recognized as being more homogeneous with respect to short-chain branch (SCB) distribution as compared with unfractionated mPEs. Differential scanning calorimetry and polarized optical microscopy (POM) were used to study the influences of SCB content on the crystallization kinetics, melting behavior, and crystal morphology of four butyl-branched mPE fractions. The parent mPE of the studied fractions was also investigated for comparative purposes. mPE fractions showed a much simpler crystallization behavior as compared with their parent mPE during the cooling experiments. The Ozawa equation was successfully used to analyze the nonisothermal crystallization kinetics of the fractions. The Ozawa exponent n decreased from about 3.5 to 2 as the temperature declined for each fraction, indicating the crystal-growth geometry changed from three-dimensional to two-dimensional. For isothermal crystallization, the fraction with a lesser SCB content exhibited a higher crystallization temperature (T-c) window. The results from the Avrami equation analysis showed the exponent n values were around 3 (with minor variation), which implied that the crystal-growth geometry is pseudo-three-dimensional. Both of the activation energies for nonisothermal and isothermal crystallization were determined for each fraction with Kissinger and Arrhenius-type equations, respectively. Double melting peaks were observed for both nonisothermally or isothermally crystallized specimens. The high-melting peak was confirmed induced via the annealing effect during heating scans. The Hoffman-Weeks plot was inapplicable in obtaining the equilibrium melting temperature (T(m)degrees) for each fraction. The relationship between T-c and T-m for the fractions is approximately T-m = T-c (degreesC) + 8.3. The POM results indicated that the crystals of parent or fractions formed under cooling conditions did not exhibit the typical spherulitic morphology as a result of the high SCB content.