Catalysis Letters, Vol.51, No.3-4, 139-147, 1998
Density functional theory (DFT) and microcalorimetric investigations of CO adsorption on Pt clusters
Microcalorimetric measurements were conducted at 573 K of CO adsorption on Pt clusters supported in L-zeolite. The measured heat of CO adsorption is 175 kJ/mol, and the heat decreases to 90 kJ/mol near saturation coverage. Quantum chemical calculations were performed using density functional theory to study the interaction of CO with 10-atom Pt clusters. The heat of CO adsorption on atop-sites is calculated to be 209 kJ/mol, while a lower heat of 142 kJ/mol is calculated for CO on bridge-sites. These values decrease to 197 and 102 kJ/mol for population of two atop-sites and two bridge-sites, respectively, on the same Pt-10 cluster. The heat of adsorption decreases to 157 kJ/mol when six CO molecules adsorb on six atop-sites of the cluster. The calculated initial heat of CO adsorption on Pt-10 clusters is in agreement with experimental and theoretical values reported for CO adsorption on Pt single-crystal surfaces. The higher heat of CO adsorption at atop-sites may be caused by more sigma-donation from CO to sp orbitals of Pt for atop-sites. The heat of CO adsorption on bridge-sites becomes higher on negatively charged platinum clusters. The calculated C-O stretching frequencies for charged and neutral platinum clusters agree with experimental data.
Keywords:SUPPORTED PLATINUM CATALYSTS;ADSORBED CARBON-MONOXIDE;ENERGY LOSS SPECTROSCOPY;ABSORPTION SPECTROSCOPY;INFRARED-SPECTROSCOPY;ELECTRONIC-STRUCTURE;ZEOLITE CATALYSTS;PT(111) SURFACE;PARTICLE-SIZE;PT/L-ZEOLITE