Journal of Physical Chemistry B, Vol.104, No.41, 9580-9586, 2000
Detection and identification of corrosion products of sodium aluminoborosilicate glasses by Na-23 MQMAS and H-1 -> Na-23 CPMAS NMR
Na-23 multiple-quantum (MQ) MAS NMR is applicable for monitoring the chemical and structural changes resulting from atmospheric exposure of a series of alkali aluminoborosilicate glasses with compositions RNa2O: 1B(2)O(3):1SiO(2):0.25Al(2)O(3) (where R = 0.5 - 2.5). Glasses with high alkali concentrations possess greater numbers of nonbridging oxygens within the bulk structure and presumably at the initial surface of a fresh sample, and for three samples with R greater than or equal to 1.5 sharp resonances are revealed in the isotropic dimension of an MQMAS NMR experiment conducted after prolonged atmospheric exposure. The MQMAS NMR experiments, combined with H-1 --> Na-23 cross-polarization magic-angle spinning (CPMAS) NMR measurements, indicate that these resonances arise from sodium cations no longer participating in the glass network. Two new phases are formed as corrosion products and have been identified as an anhydrous Na2CO3 phase and a NaBO2. 1H(2)O phase through comparison with Na-23 MQMAS and H-1 --> Na-23 CPMAS NMR spectra of crystalline samples. Due to an inherent difficulty with direct quantification of populations based on MQMAS spectra, a simplified approach for quantification of the amount of the new carbonate phase is presented. Values are then calculated for relative amounts of corrosion product formation for different exposure times and bulk glass compositions.