Tailor-made urethane acrylate anionomer (UAA) chains show higher viscosity and polyelectrolyte behavior in dimethyl sulfoxide (DMSO) than in water and toluene. Water is a nonsolvent for the hydrophobic soft segment but a good solvent for the hydrophilic hard segments, so hydrophobic segments are aggregated and form particles in the water phase, resulting in a smaller viscosity. Also, the fact that the viscosity of UAA chains is lowest in toluene can be interpreted as a result of ionic aggregation due to the nonpolarity of toluene. The structures of UAA networks dramatically change with the nature of the solvents used (i.e., the interaction between the UAA chains and the solvents used changes); this is confirmed by the results of tensile property, morphology, and wide-angle X-ray scattering data. Ionic aggregation formed in UAA/tuluene (UATG networks) and hydrophobic aggregation formed in UAA/water (UAAG networks) are locked in by a chemical crosslinking reaction and result in a greater modulus and X-ray scattering intensity. The greater elongation and swelling ratio in methylene chloride of UATG networks prepared in a UAA/toluene solution indicates that toluene is a better solvent than DMSO for the hydrophobic segments of UAA chains. Also, the greater swelling ratio in a pH 11 buffer solution and greater modulus of UAAG networks show that water is a better solvent than DMSO for hydrophilic ionic segments.