Ni supported catalysts were prepared by the solid phase crystallization (spc) method starting from hydrotalcite (HT) anionic clay based on [MgsAl(2)(OH)(16)CO32-].H2O as the precursor. The precursors were prepared by the co-precipitation method from nitrates of the metal components, and then thermally decomposed, in situ reduced to form Ni supported catalysts (spc-Ni/Mg-Al) and used for the CO2 reforming of CH4 to synthesis gas. Ni2+ can well replace the Mg2+ site in the hydrotalcite, resulting in the formation of highly dispersed Ni metal particles on spc-Ni/Mg-Al. The spc-catalyst thus prepared showed higher activity than those prepared by the conventional impregnation (imp) method such as Ni/alpha -Al2O3 and Ni/MgO. When Ni was supported by impregnation of Mg-Al mixed oxide prepared from Mg-Al HT, the activity of imp-Ni/Mg-Al thus prepared was not so low as those of Ni/alpha -Al2O3 and Ni/Mgo but close to that of spc-Ni/Mg-Al. The relatively high activity of imp-Ni/Mg-Al may be due to the regeneration of the Mg-Al HT phase from the mixed oxide during the preparation, resulting in an occurring of the incorporation of Ni2+ in the Mg2+ site in the HT as seen in the spc-method. Such an effect may give rise to the formation of highly dispersed Ni metal species and afford high activity on the imp-Ni/Mg-Al.