Many composite manufacturing methods are room temperature processes, which require the resins to be cured at low temperatures. Examples are Seemann Composite Resin Infusion Molding Process (SCRIMP)-a vacuum assisted resin transfer molding (VARTM) process, hand lay-up and spray-up. Vinyl ester resins have been widely used in this type of processes because of their versatility as a composite matrix. Low temperature polymerization between styrene and vinyl ester tends to be complex because of the presence of different curing agents. This paper reports on 1) the effects of a promoter (cobalt naphthenate) on the initiation at low temperatures, and 2) the effects of a retarder (2,4-pentanedione) and an inhibitor (1,4-benzoquinone) on the pot life, gel time, and cure kinetics. A differential scanning calorimeter (DSC) and a Fourier transform infrared (FTIR) spectrometer were used to investigate the reaction kinetics of vinyl ester resins. The influence of the retarders and inhibitors on the theological changes of the resin during curing was also studied using a Rheometrics Dynamic Analyzer (RDA).