The strength of symmetric anode/electrolyte/anode and cathode/electrolyte/cathode planar multiple electrode assemblies (MEAs), fabricated by screen printing electrodes onto pre-fired tape-cast electrolyte plates was measured in biaxial flexure. The electrolyte was Zr0.84Y0.16O1.92 (YSZ), the anode NiO/YSZ and the cathode La0.75Sr0.2MnO3-delta. The residual stress in the electrodes was estimated by curvature measurement after removal of one electrode. The residual stress in the anodes was very low (11 MPa) due to stress relief by extensive channel cracking. The residual stress in the cathodes was much higher (39 MPa) and was in reasonable agreement with the expected thermoelastic stress. The applied load at failure, and the stress in the electrolyte at failure (343 MPa), for anode MEAs were almost equal to those of electrolyte plates (374 MPa). This is consistent with the low residual stress and observed crack deflection by delamination at the anode/electrolyte interface. The applied load at failure, and the stress in the electrolyte at failure (182 MPa), for cathode MEAs were much lower. This is partially explained by the residual stress in the cathode acting to increase the applied stress intensity at defects in the electrolyte, but this effect is not large enough to explain fully the reduced strength.