The surface of a poly(styrene-hydroxyethylmethacrylate), macrocrystalline film was observed by atomic force microscopy in the contact mode, before and during film immersion in water. The swelling effect on film morphology is strongly dependent on the quality of the macrocrystalline surface: film integrity is preserved or concerted many-particle displacement is observed in well-organized areas with few defects, but extensive particle displacement is observed in highly defective areas. The lateral particle dimensions increase by ca. 10-15% only and particle aspect ratio is unaltered in the highly crystalline areas. However, him roughness is greatly decreased, and hat mirror-like surface domains are obtained due to the concerted effects of particle swelling and latex-water interfacial tension.