Spherical polyacrylamide/magnetite (PAM) composite beads, suitable for use in a magnetically stabilized fluidized bed (MSFB), were manufactured by a suspension polymerization method. Yield of beads depended on the type and concentration of buffer used during polymerization as well as the pH. More stabilizer was needed to prevent bead agglomeration as magnetite concentration increased. Bead diameter ranged from less than 60 to 600 mu m, depending on reaction conditions, and the bead mean diameter and size distribution decreased with increasing impeller speed. The density and roundness factor of the beads were 1.19 +/- 0.02 g cm(-3) and 1.08 +/- 0.03, respectively. The beads had high magnetization at a low applied magnetic field strength (60 mT at 75 kA m(-1)) and retained little residual magnetization (<2 mT) after the field was removed. Incorporation of magnetite did not significantly affect the physical strength of the beads : the beads’ average elastic modulus was 14 +/- 4 kPa, similar to reported values for polyacrylamide gels (15.8 kPa). The beads were stable in a range of buffers from pH 1 to 10 and were resistant to microbial degradation. The fluidization and stabilization behavior of the beads was examined in a bench-scale MSFB. The minimum fluidization velocity (U-mf) of the beads (0.035 mm s(-1)) allowed the MSFB to be operated at superficial velocities close to those used in HPLC systems. Against expectations, at high superficial velocities, the stabilized bed of the MSFB had a greater expansion than the unstabilized bed. The PAM beads could be derivatized and activated for soybean trypsin inhibitor immobilization by a standard carbodiimide method, and the affinity separation of trypsin from chymotrypsin was demonstrated. The PAM beads show excellent potential for use in MSFB chromatography.