A series of titania supported molybdenum catalysts were prepared by incipient wetness impregnation method and characterized by BET surface area, XRD, TPR, FTIR, ESCA, and low temperature oxygen chemisorption. Thiophene. cyclohexene and tetrahydrofuran were taken as model compounds for evaluating catalytic activities for hydrodesulfurization (HDS), hydrogenation (HYD), and hydrodeoxygenation (HDO) reactions, respectively. XRD results indicate that molybdenum oxide species are dispersed as a monolayer on the support up to 8 wt.% Mo and the formation of crystalline MoO3 is observed above this loading. FTIR and TPR results showed that molybdenum oxide species were present predominantly in tetrahedral form at lower loading and polymeric octahedral forms are dominant at higher loading. Both oxygen chemisorption and rates of reaction were found to increase with increasing Mo loading up to 8 wt.% and then decrease with further increase in loading. HDS and HYD activities are more or less same but HDO activity is two times higher than HDS and HYD activities. The results are also interpreted with the help of other parameters, like dispersion, equivalent molybdenum surface area, surface coverage, crystalline size, quasi-turnover frequencies and intrinsic activities. ESCA results suggest that electron transfer is taking place from support to metal.