An investigation has been performed of the cell nucleation and initial growth behaviors in the foam processing of polypropylene (PP) in both the linear and branched forms. These materials were foamed in extrusion with the two blowing agents, CO2 and isopentane. The cell density generally increased with an increased content of the blowing agent, for both CO2 and isopentane. The effect of processing pressure on the cell density was distinct when CO2 was used, whereas no pressure effect was observed in the foam processing with isopentane. The cell morphologies for the two PPs were found to be significantly different. A slightly lower nuclei density was observed in the branched PP foams than in the linear PP foams. However, the phenomenon of cell coalescence was observed much less in the branched PP foams. Most cells in the branched PP foams were closed, whereas in the linear PP foams they were connected to each other. The experimental results indicated that the branched structure played an important role in determining the cell morphologies through its effects on the melt strength and/or melt elasticity.