This work is concerned with the extrusion blow molding of bottles from pellets of polypropylene (PP) containing pregenerated microfibrils of thermotropic liquid crystal polymers (TLCPs), referred to as microcomposites. The TLCPs used are HX6000 and Vectra A950. The microcomposites are produced by drawing strands of PP and TLCPs generated by means of a novel mixing technique and pelletizing the strands. The work was undertaken in an effort to improve on the properties observed for in situ composites in which the TLCP fibrils are generated in elongational flow fields that occur in polymer processing operations and to determine if TLCP reinforced bottles could be produced by extrusion blow molding of microcomposites. In situ composites usually exhibit highly anisotropic mechanical properties and the properties do not reflect the full reinforcing potential of the TLCP fibers. Factors considered include the effect of TLCP concentration and in situ composite strand properties on the mechanical properties and anisotropy of bottles made from microcomposites. Specifically, strands having three different draw ratios are used to produce bottles at 10 and 20 wt% TLCP. Increasing the in situ composite strand modulus is shown to cause an increase in both the machine and transverse direction moduli of the composite bottles. The mechanical properties of the bottles increase with increasing TLCP composition. Finally, the machine and transverse direction properties are not balanced in the composite bottles produced in this study (degrees of anisotropy ranging from 1.5 to 1.8). The mechanical anisotropy is probably the result of a low blow up ratio (2) in the bottles and the TLCP fibers being oriented primarily in the machine direction due to the shear flow in the die.