Four isotropic polymers, poly(butylene terephthalate) (PBT), polycarbonate (PC), polyethersulfone (PES) and polysulfone (PSU), were blended by extrusion with a thermotropic liquid crystalline polymer (LCP) at different temperatures. The morphology of extrudates was observed by means of scanning electron microscopy and the intrinsic aspect ratio of LCP fibrils and particles separated from matrix resin was measured with an image analysis. Special attention was paid to the LCP fibrillation in these four matrices in a wide temperature range from 270 to 360 degrees C and the internal relations among the effects of processing parameters, such as viscosity ratio, extrusion temperature, and LCP concentration. The results show that the viscosity ratio of the dispersed LCP phase to the continuous phase is a decisive factor determining the formation of LCP fibrils, but its effect closely relates with the LCP content. In the range of viscosity ratios investigated, 0.004 to 6.9, and lower LCP content of 10%, significant fibrillation took place only at viscosity ratios below 0.01. It is predicted that the upper Limit of the viscosity ratio for LCP fibrillation will increase with increasing LCP content. A comparison of the morphologies of LCP/PES blends with different LCP concentrations reveals that the LCP phase becomes continuous at a concentration of less than 50%, and high LCP content does not always favor the formation of long and uniform LCP fibrils. The extrusion temperature has a marked effect on the size of the minor LCP domains. For fibril forming systems, the percentage of LCP fibrils with larger aspect ratios increases with increasing extrusion temperatures. All these results are explained by the combined role of deformation and coalescence of the LCP dispersed phase in the blend.