Differential scanning calorimetry (DSC) was used to investigate the solid-state cure process of poly(phenylene sulfide)(PPS) resin. Virgin PPS resin in an open sample pan was cured in DSC cell. Either air or oxygen was used as a curing atmosphere. Cure temperatures were in the range of 200 and 250 degrees C, which are below the melting point of PPS resin. Cure temperature as well as atmospheric condition influenced the cure behavior of PPS in the solid state. Both the rate and the amount of cure increased with increasing cure temperature. On the other hand, the time to reach the maximum cure rate was independent of cure temperature. Changing the atmosphere from air to oxygen increased both the cure rate and the amount of cure. The size effect of PPS particles on the cure reaction was also discussed. Differential scanning calorimetry (DSC) was used to investigate the solid-state cure process of poly(phenylene sulfide)(pps) resin. Virgin PPS resin in an open sample pan was cured in DSC cell. Either air or oxygen was used as a curing atmosphere. Cure temperatures were in the range of 200 and 250 degrees C, which are below the melting point of PPS resin. Cure temperature as well as atmospheric condition influenced the cure behavior of PPS in the solid state. Both the rate and the amount of cure increased with increasing cure temperature. On the other hand, the time to reach the maximum cure rate was independent of cure temperature. Changing the atmosphere from air to oxygen increased both the cure rate and the amount of cure. The size effect of PPS particles on the cure reaction was also discussed.