A series of well defined poly(methyl methacrylate) (PMMA)-b-poly(n-butyl acrylate) (PnBA)-b-PMMA triblock copolymers (MnBM) has been synthesized by transalcoholysis of PMMA-b-poly(tert-butylacrylate) (PtBA)-b-PMMA precursors (MTM) by n-butanol. Phase separation is observed for all the investigated triblock copolymers, which contain PMMA outer blocks in the 5000-50 000 molecular weight (MW) range and PnBA inner blocks with MW in the 100 000-200 000 range. Although the ultimate tensile properties of these MnBM triblock copolymers are poor compared to traditional diene-based TPEs (SBS and SIS), they are much better than those ones reported for PMMA-b-poly(isooctyl acrylate) (PIOA)-b-PMMA triblocks (MTM). A reasonable explanation for this observation is found in the average molecular weight between chain entanglements (M-e) that has been estimated to be 28 000 for the central PnBA rubbery block, which is consistently much smaller than for PIOA (59 000) and substantially higher than M-e for polybutadiene (1700) and polyisoprene (6100). The tensile behavior of MnBM copolymers cannot be fitted by either a simple elastomer model free from chain entanglements (suitable to MIM) or by a "filler" modified rubber model (suitable for diene-based TPEs), supporting the hypothesis that the mechanical properties of the investigated (meth)acrylate thermoplastic elastomers are significantly affected by any change in M-e of the central acrylate block. Viscoelastic analysis shows that MnBM triblocks are of higher complex viscosity than the SBS and SIS analogs, leading to a shift in the order-disorder transition temperature to much higher temperature, unless the outer PMMA blocks are of very low molecular weight (5000).