Water-based cooling methods increase the output power of photovoltaic (PV) panels. One of the most promising methods is an irrigation of the front surface of a PV panel. Although some studies have experimentally investigated this method, there remains a lack of information for predicting the operating temperature of a PV panel (T-PV) during the irrigation cycle. Therefore, in this study, a dynamic thermal model (RC model) is proposed to predict the T-PV and water temperature (T-wtq) during an intermittent irrigation cycle relying on the energy balance of the PV panel and irrigation water, which in turn is based on a dynamic thermal model of a non-irrigated PV panel that shows a good performance for quick variations in the solar irradiance and air velocity. The use of both models allows studying the three thermal transients that a PV panel can experiment during intermittent irrigation, direct cooling, indirect cooling, and heating, as well as the processes of heating and convective cooling of water in the tank. Two experiments were conducted to establish the thermal capacitance per unit area of a PV panel (c(sPV)) and superficial conductance (h) for three air velocities (0.0, 1.15, and 2.10 m/s). The models were validated using an experimental setup with PV panels (255 W); three validation cases (for a typical day, with forced ventilation, and constraining the heat transfer) were conducted for a non-irrigated operation using NRMSETPV of 4.0%e5.2%; in addition, the model was validated for an intermittent irrigation operation during the day with NRMSETPV and NRMSETwtq of 5.5% and 5.6%, respectively. Results indicate that both RC models can predict successfully the behaviour T-PV, even when face intense thermal transients caused by abrupt changes of solar irradiance and air velocity and the intermittent irrigation on front surface of the PV panel. (c) 2020 Elsevier Ltd. All rights reserved.