We report on the effect of the substrate on electro- chemical deposition of Cu from deep eutectic solvent ethaline. We investigated the polarization behavior during electrodeposition of Cu on Pt and glassy carbon (GC) from both Cu2+ and Cu+ containing ethaline using cyclic voltammetry (CV). Formation of bulk Cu deposits on both substrates underwent nucleation and growth processes; however, the nucleation was considerably sluggish on GC compared to Pt. While experiments in Cu+ solutions indicated that coalescence of Cu islands on Pt is a slow process and that its surface may not be fully covered by Cu, such determination of Cu coverage could not be made on GC. Cu dissolution is also slower from GC than from Pt. It was observed that CV of Cu deposition on GC is influenced by the surface preparation method. Since ethaline has high chloride concentration, a parallel study in aqueous 3 M NaCl solution was conducted in order to examine the influence of the chloride medium on the electrodeposition process. This revealed that electrodeposition in both media occurred in the same manner but with different charge and mass transfer rates caused by the differences in viscosity and chloride concentrations of the two solutions.