The mobility of gas is greatly reduced when the injected gas is foamed. The reduction in gas mobility is attributed to the reduction in gas relative permeability and the increase in gas effective viscosity. The reduction in the gas relative permeability is a consequence of the larger amount of gas trapped when foam is present while the increase in gas effective viscosity is explicitly a function of foam texture. Therefore, understanding how foam is generated and subsequent trapped foam behavior is of paramount importance to modeling of gas mobility. In this paper, we push the envelope to enlighten our decisions of which descriptions are most physical to foam flow in porous media regarding both the flowing foam fraction and the rate of generation. We use a statistical pore network interwoven with the invasion percolation with memory algorithm to model foam flow as a drainage process and investigate the dependence of the flowing foam fraction on the pressure gradient and to shed light on foam generation mechanisms. A critical snap-off probability is required for strong foam to emerge in our network. The pressure gradient and, hence, the gas mobility reduction are very low below this critical snap-off probability. Above this snap-off probability threshold, we find that the steady-state flowing lamellae fraction scales as ( backward difference p0.19in 2D lattices and as ( backward difference in 3D lattices. Results obtained from our network were convolved with percolation network scaling ideas to compare the probabilities of snap-off and lamella division mechanisms in the network during the initial gas displacement at the leading edge of the gas front. At this front, during strong foam flow, lamella division is practically nonexistent in 2D lattices. In 3D lattices, lamella division occurs, but the probability of snap-off is always greater than the probability of lamella division.