This work introduces a sustainable alkaline membrane fuel cell, SAMFC, stack. The SAMFC includes a reactor that uses recycled aluminum to break the water molecule via the oxidation of aluminum catalyzed by NaOH in order to generate hydrogen to feed system. A cellulosic membrane supports the liquid electrolyte. CO2 purified air is obtained from atmospheric air that is filtered by a KOH solution, so that potassium carbonate is not formed. The prototype consisted of a four single alkaline membrane fuel cells, AMFC, the H-2-producing reactor, and the CO2 purifier. The SAMFC performance is evaluated via direct voltage and power. Although residual Al from soda cans was utilized, the results showed that the SAMFC stack delivered a maximum 3.77 V (I = 0 A) and 2.70 W of maximum power, which is only 18% lower than the same AMFC stack fed with pure H-2. In parallel, a simplified SAMFC stack transient mathematical model numerical results were validated by direct comparison to experimental data. A parametric analysis investigated the impact of electrolyte KOH mass fraction variation (y = 20%, y = 40%, and y = 50%) on performance, showing that there was an optimal condition, y(opt) = 40% w/w, for maximum SAMFC net power output, which was the adopted value in this work's experiments. Remarkable is that the maximum is sharp, since the net power drops by similar to 42% with y = 50% w/w, and by 50% with y = 20% w/w in comparison to y = 40% w/w. It is concluded that in situ sustainable H-2 generation coupled with the fuel cell stack showed potential to be a viable sustainable power generation system in the near future, mainly if operating at the herein found optimal operating conditions. (C) 2019 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.