Chemi-mechanical pulping, a typical high-yield pulping method, combined with autohydrolysis pretreatment prior to pulping is an efficient and value-added utilization method for biomass in pulp and paper industry. This study investigated the surface lignin changes of poplar sapwood chips in autohydrolysis pretreatment and their effect on the subsequent alkali impregnation for chemi-mechanical pulping. The results showed that the surface lignin content went up with the increase of autohydrolysis intensity, and that the existence of the surface lignin had nearly no impact on the subsequent alkali impregnation in making chemi-mechanical pulps (CMPs) compared to the volume porosity, which was validated by using the stepwise regression analysis. It can be further concluded that autohydrolysis can facilitate the subsequent alkali impregnation of the autohydrolyzed sapwood chips in making CMP, which would be of significance for the combination of biomass refinery and pulp and paper industry.