This paper presents data reduction of average friction factor of gas flow through adiabatic micro channels. In the case of micro-channel gas flow at high speed, the large expansion occurs near the outlet and the pressure gradient along the length is not constant with a significant increase near the outlet. This results in flow acceleration and a decrease in gas temperature. Therefore the friction factor of micro channel gas flow should be obtained with measuring both the pressure and temperature. The data reductions on friction factors were carried out under the assumption of isothermal flow for numerous experimental and numerical studies since temperature measurement of micro-channel gas flow at high speed is quite difficult due to the measurement limitations. In the previous study, it was found that the gas temperature can be determined by the pressure under the assumption of one dimensional flow in an adiabatic channel (Fanno flow). Therefore in the present study data reduction to estimate friction factors between two relatively distant points considering the effect of a decrease in temperature is introduced with the temperature determined by the measured pressure at a specific location. The Friction factors obtained by using the present data reduction are examined with the available literature and the results are compared with empirical correlations on Moody chart. (C) 2018 Elsevier Ltd. All rights reserved.