Microwave-assisted hydrothermal method was applied to obtain SrTiO3 photocatalyst by transformation of a thin TiO2 layer deposited on the conducting solid substrate (FTO-glass) via dissolution-precipitation reaction in alkaline solution. The influence of Sr2+ ions concentration on crystallinity, composition as well as photoelec-trochemical and photocatalytic properties of the resultant materials was investigated. The XRD studies indicated the presence of some amount of co-deposited SrSiO3 due to reaction of metasilicates released from the glass substrate (not covered with FTO film). However, the process of glass dissolution was substantially prevented by protection of the back side of the sample with a Teflon tape. The best activity in photodecomposition of 4-chlorophenol under irradiation with 365 nm diode was obtained for FTO/TiO2/SrTiO3 composite fabricated in 6 h synthesis in the solution containing 0.1 M Sr(NO3)(2), at temperature of 180 degrees C. The photoelectrochemical properties of the composites and FTO/TiO2 electrode were studied in the solution of Na2SO4 under illumination with a xenon lamp. The increased photocurrent density and longer electron lifetime for the hybrid system in comparison to those of TiO2 was discussed in terms of suppressed recombination rate due to formation of TiO2/SrTiO3 interface. It was also found that the side product, SrSiO3, reveals an excellent adsorption properties with respect to methylene blue and therefore, the system SrTiO3/TiO2/FTO/glass/SrSiO3 may be used as bifunctional composite for adsorption and photocatalysis.