In present work, we synthesized ZnFe2O4 nanorods on a fluorine-doped tin oxide substrate using spray coating method followed by two-step high-temperature quenching (HTQ). X-ray photoelectron spectroscopy (XPS) results indicate that Sn4+ is diffused from the FTO substrate after the second quenching, which could help in minimizing the recombination of photogenerated carriers. Photoelectrochemical measurements of the ZnFe2O4 nanorod photoelectrodes quenched at 780 degrees C, 800 degrees C, and 820 degrees C indicate that among the studied samples (ZFO1, ZFO2 and ZEO3), the highest photocurrent density was observed for nanotextured ZFO3 photoelectrodes (130 mu A cm(-2) at 1.23 V vs RHE). The photoelectrochemical performances of the ZnFe2O4 nanorods after the second quenching were compared with those of the firstly quenched ZnFe2O4 nanorod samples; water-oxidation photocurrent density of the former (ZFO3) was increased by 6.9 times compared with that of the first quenching (PZFO). Intensity modulated photocurrent spectroscopy (IMPS) and photoluminescence (PL) results confirm the faster charge extraction was achieved for the ZFO(3) photoelectrode. Thus, the overall photocurrent density during the second quenching process results from the effectively improved crystallinity, the reduced strain and suppressed charge-carrier recombination's on both the surface as well as in the bulk of the ZnFe2O4 nanorods. In terms of solar water splitting, these research findings provide an effective route for the synthesis of other nanostructures.