This work is aimed at investigating the influence of fibrillar morphology of deformed Polyamide 6 (PA6) droplets dispersed in Polypropylene (PP) matrix on the melt viscoelastic behavior of their blends. The blends of PP with various amounts of PA6 (1%, 6%, 10%, and 20%) were prepared by melt mixing in a co-rotating twin screw extruder and fibrillated by fiber spinning process. Scanning Electron Microscopy revealed that the PA6 spherical droplets form fibrillar inclusions after fiber spinning. The steady and transient shear rheological responses of samples were evaluated in both linear and nonlinear ranges of deformation. Non-terminal behavior of storage modulus at low frequency appeared as a typical characteristic of fibrillar morphology whose width and value depend on fibril growth. Storage modulus and complex viscosity of the blends containing PA6 fibrillated structure were remarkably enhanced compared to as-extruded samples. The fibrillar-induced elasticity of the fibers is a distinguishable behavior which was revealed by conducting transient stress and creep-recovery measurements and upon appearing mature fibrils, elasticity of the polymer blend fibers increased significantly. POLYM. ENG. SCI., 58:1251-1260, 2018. (c) 2017 Society of Plastics Engineers