Doped polyaniline (PANI) is well-known as an electronic (polaronic) conductor and mostly is used as semiconductor in various applications. However, in the literature there are examples of employment of the acid doped form of PANI as electrolytic filler in proton exchange membranes. In order to distinguish between two types of conduction, in the present study powdered samples of polyaniline, either in the form of emeraldine base (PANI-EB) or in the form doped with camphorsulfonic acid (PANI-CSA), were investigated using impedance spectroscopy both in the dry state and in contact with liquid water. The obtained spectra were compared with the spectra of such conventional solid electrolytes, as zeolites X and ZSM5 and a strong electrolyte boron orthophosphate, acquired in identical conditions. The most important dissimilarity between conventional electrolytes and PANI was that ion diffusion dominates in the impedance response of the formers, whereas the behavior of PANI is under control of electron/hole displacement and the diffusion part is quite inessential. This corroborates the results of analysis of temperature dependence of PANI conductivity, which revealed values of activation energy twice as large as typical solid electrolytes. Equivalent circuits, simulating the impedance responses of all materials, were built up and used to estimate a possible diffusion coefficient of cations in the comparable solids. It was found that the diffusion in a strong electrolyte such as BPO4 is similar to 2 orders of magnitude faster than evaluated for zeolites and similar to 4 orders higher than what was PANI estimation. A conclusion was made that the slow cation diffusion both in protonated and in base form of PANI makes them less efficient solid electrolytes than conventional materials.