An experimental study was conducted to investigate the 2D bubbly flow downstream of a cylinder. Sparsely distributed bubbles were produced using the ventilation method. The carrier flow was measured using the particle image velocimetry (PIV) technique. The shadow imaging technique was used to capture instantaneous bubbly flow images. An image-processing code was compiled to identify bubbles in acquired image, calculate the bubble equivalent diameter and the bubble velocity. The effects of Reynolds number and the flow rate of the injected air were considered. The result indicates that the carrier flow is featured by distinct flow structures and the wake region is suppressed as the upstream velocity increases. Regarding the bubbles trapped in the wake flow, the number of small bubbles increases with the upstream velocity. On the whole, the bubble velocity is slightly lower than that of the carrier flow. The consistency between small bubbles and the carrier flow is high in terms of velocity magnitude, which is justified near the wake edge. The difference between the bubble velocity and the carrier flow velocity is remarkable near the wake centerline. For certain Reynolds number, with the increase in the air flow rate, the bubble equivalent diameter increases and the bubble void fraction is elevated. (C) 2018 The Chemical Industry and Engineering Society of China, and Chemical Industry Press. All rights reserved.