Imide units copolymerized with MMA units have been selected in order to improve compatibility between PC and acrylics through specific interaction or internal repulsion. Good dispersion of acrylic inside a PC matrix has been observed upon melt mixing, which can be partially explained by the good rheological agreement between these two polymers. Transmission electron microscopy has shown that the system remains phase separated from 5 to 95 wt % of PC. Phase diagrams for three different imide concentrations have been drawn. Results obtained by DSC (conventional and with enthalpy relaxation) are similar to those obtained by optical cloud point detection. The phase diagrams show the raise of the PC/PMMA demixtion curve (LCST type) when percentage of imide increases in the acrylic phase. Theoretical calculations on binary interaction energy density show a slight improvement of the interaction between acrylic and PC when imide percentage increases. Cloud point measurements on 50/50 PC/acrylic blends varying the imide concentration show that the improvement of compatibility deduced from the raise of the demixtion curve ( LCST type) is more related to a kinetic effect (the high T-g of imidized samples is reducing macromolecule mobility) than specific interactions. The calculated favorable interactions are probably too weak to be detected with cloud point measurements. The microstructures obtained after crystallization of the PC phase under solvent vapors is phase separated PC/acrylics blends can also be explained by T-g effects. Moreover, solvent vapor exposure could be a powerful tool to determine the real thermodynamic behavior of the blends at room temperature.