Liquid chromatography of macromolecules at the critical adsorption point (LC CAP) presents a potentially very powerful method for molecular characterization of complex polymers. However, LC CAP applicability is limited due to various experimental problems. The pore sizes and surface chemistry of the column packings belong to the most important weak points of the method. The LC CAP behavior of poly( methyl methacrylate)s was investigated using bare silica gels of 6, 12, and 100 nm pore sizes and with various amounts of surface silanols. Tetrahydrofuran as the adsorption suppressing liquid and toluene as the adsorption promoting liquid were mixed to form the "nearly critical" eluents. Both pore size and surface chemistry of silica were found to strongly influence the retentive characteristics of the system in the critical adsorption area. Macromolecules that were large enough to be excluded from the packing pores hardly followed the LC CAP rules : their retention volumes changed irregularly with the polymer molar mass and their recovery dropped sharply. The narrow pore silica gel-packed column governed the elution patterns of the whole column set composed of silica gels with different pore sizes. This makes the conventional LC CAP characterization of common polymers with broader molar mass distribution impractical and even not feasible. A hybrid column system was proposed containing narrow pore nonadsorptive column added in series to the meso-and macroporous LC CAP silica gels. This narrow pore column would allow separation of gas, impurities, and system peaks from the polymer peaks. The possible successive changes of the surface of silica gel, e.g., due to formation of silanols by hydrolysis or due to irreversible adsorption of some admixtures from the sample or eluent may make the LC CAF irrepeatable. Pronounced peak broadening was observed in the critical adsorption area and this effect increased strongly with the polymer molar mass.