The photolitography method was used for producing interdigitated configurations for cathode and anode electrodes of a field ionization gas sensor in which Mn helical nano-flowers with 3-fold symmetry were deposited using oblique angle deposition together with rotation of the substrate about its surface normal, with each rotation divided into six sections. These sections were alternately rotated at high and low speeds. Three different distances were chosen in the design between anode and cathode electrodes, namely 40, 100 and 200 mu m. Physical structure and morphology of electrodes were studied by field emission scanning electron microscope and atomic force microscope analyses. The breakdown voltage of the system was studied for nitrogen, oxygen, argon, air and carbon mono-oxide gases. Investigations with these gases at different distances between anode and cathode and different gas pressures confirmed Paschen's Law. Results showed that at low pressures, decreasing the gap between electrodes increases the breakdown voltage. With fewer gas molecules between the electrodes the number of interactions between particles is reduced and higher energies are required for ionization of gas molecules. At high pressures, the breakdown voltage is decreased because of an increased number of molecular interactions. The sensor demonstrated good selectivity between the different gases and selectivity was enhanced with increasing gas pressure. A direct relationship was found at low pressures (e.g., 0.1 mbar) between the breakdown voltage and the gas ionization energy while at high pressures (e.g., 1000 mbar) this relationship was reversed.