Supercritical carbon dioxide (S-CO2) cycle is proven to be one promising alternative to provide high efficiency and has been developed for a wide range of energy conversion applications. Thermal efficiency of the S-CO2 cycle can be further improved by incorporating an appropriate bottoming cycle utilizing the residual heat. In this paper, an Organic Rankine Cycle (ORC) is added to the S-CO2 cycle for heat recovery. Different recuperative ratios of the topping S-CO2 cycle are considered and the influence of heat source initial temperature and total heat load on the bottoming ORC is evaluated. Two configurations of the S-CO2-ORC combined cycle system are presented, one without a pre-cooler and the other still with a pre-cooler, corresponding to total and partial residual heat recovery respectively. Though the entire residual heat recovery by the bottoming cycle could definitely increase the system thermal efficiency, the low ORC evaporation temperature and mediocre ORC performance leads to a limited improvement. While in the combined cycle system with a pre-cooler, higher ORC evaporation temperature could be attained and it has a remarkable effect on the ORC performance, even though part of the topping cycle residual heat is discharged to the ambient. The simulation results reveal that the S-CO2-ORC combined cycle system performance could be significantly improved through this parametric optimization. The recompression S-CO2 cycle with bottoming ORC is then analyzed and thermal performance is improved based on the previous optimization results. The bottoming ORC could effectively recover the residual heat of the topping S-CO2 cycle and increase the system thermal efficiency, thus it can be considered and applied in similar practical cases. (C) 2017 Elsevier Ltd. All rights reserved.