Silver vanadates thin films were deposited by a hybrid deposition system combining laser ablation and thermal evaporation. A high purity vanadium target was ablated using the third harmonic of a Nd:YAG laser whereas high purity silver pellets were evaporated. The as-deposited thin films were subjected to thermal treatments at 400 degrees C to obtain crystalline films. For films without Ag amorphous V2O5 thin films were deposited and as the Ag is incorporated in the material different silver vanadates were obtained. The effect of the silver load on the composition, structure, optical properties, surface morphology and photocatalytic response of the deposited films was studied. The film composition, determined by X-ray photoelectron spectroscopy, reveals Ag contents from 5.5 to 18.9 at.%. The crystalline phases formed were identified by micro-Raman Spectroscopy; the results indicate the formation of three silver vanadates depending on the silver content. The morphology was observed using scanning electron microscopy, the films surface changes from a smooth surface to belts covering the surface and finally Ag nanoparticles are observed at the higher Ag contens. Optical properties determined from UV-vis reveal the presence of the surface plasmon signal in films containing silver. The films were tested in the photocatalytic degradation of Malachite Green dye reaching maximum degradations degrees close to 53% under solar irradiation. Reactive species trapping experiments suggest that O-2(-)center dot produced by the O-2 reduction via the photogenerated electrons drives the photodegradation mechanism.