화학공학소재연구정보센터
Chemical Engineering and Processing, Vol.122, 277-287, 2017
Hydrodynamic study of a monolith-type reactor for intensification of gas-liquid applications
Two-phase monolith-type reactors allow intensified heat and mass transfer rates, but often suffer from fluid maldistribution and undesired flow regimes in channels. A cold-flow monolith reactor (0.1 m diameter, 84 channels) is used here to assess liquid distribution and flow regimes at various air and water velocities: resistive probes give an insight of the flow patterns within 5 representative channels located at different radial positions, showing that regime transition to Taylor flow occurs in these channels simultaneously at lower gas and liquid superficial velocities than predicted by single capillary studies (namely u(L), and u(G) < 0.1 m s(-1)). A full mapping of the partial liquid flow rates in the monolith channels is derived by a gravimetric method via specifically designed collectors. In the identified Taylor flow domain, liquid distribution exhibits a W-shaped profile with marked peaks at low liquid velocity (u(L) = 0.04 m s(-1)). Increasing the liquid flow rate significantly (u(L), = 0.1 m s(-1)) smooths liquid distribution, reducing the maldistribution factor by half. Gas velocity also helps phase uniformity but to a smaller extent. It is estimated that even higher fluid velocities (at least tripled) would be required to feed all channels equally. Adding stack of distribution plates of variable cell density at the top of the monolith does not enhance the quality of the liquid distribution, except at low liquid velocity.