This study aims to elucidate the separation of phenol by reverse osmosis (RO) and forward osmosis (FO) modes and propose strategies to enhance phenol rejection by these two processes. The results show that phenol rejection was strongly influenced by water flux, membrane materials, membrane structure, modes of operation, and feed solution chemistry (i.e. pH). The relationship between phenol rejection and water flux was demonstrated by the irreversible thermodynamic model which could accurately simulate phenol rejection as a function of water flux. At pH 7, phenol rejection by cellulose acetate (CTA) membranes was negligible while the thin film composite (TFC) polyamide (PA) membranes exhibited much higher phenol rejection. Through a systematic static adsorption experiment, results in this study show that phenol adsorption to CTA material was about 20 times higher than that to PA material. Thus, the observed higher phenol rejection by TFC PA compared to CFA membranes was attributed to the significantly higher affinity of phenol toward CTA and the sorption diffusion transport mechanism of phenol through the membrane. In particular, a TFC PA membrane specific for FO operation was prepared in this study. In FO mode, the tailor-made TFC PA membrane showed a slightly higher phenol rejection and a much higher water permeability compared to the commercial membrane. At the same water flux and solution pH, phenol rejection in FO mode was consistently higher than in RO mode. This observation could possibly be attributed to the reverse diffusion of draw solutes in the FO mode which hinders the forward diffusion of phenol through the membrane. A significant increase in phenol rejection was achieved by increasing the feed pH above the dissociation constant of the compound. (C) 2017 Elsevier B.V. All rights reserved.