Bubble column reactors are widely used for gas-liquid operations and most often are fitted with vertical internals for appropriate heat transfer. Apart from these applications, cylindrical vessels with concentrically installed vertical tube bundles find major use in boiling water reactors. Most often, heat removal takes place in boiling water reactors by phase change of the flowing water, which results in a complex, axially developing and highly dynamic two-phase flow pattern. Though the hydrodynamics in a bubble column with vertical internals have been addressed in few publications, the characteristics of liquid phase mixing and turbulence over a wide range of operating conditions and dense configuration of the internals have not been reported thus far. The present communication addresses the hydrodynamic characteristics in bubble column equipped with dense internals over a wide range of superficial gas and liquid velocities. Experiments were performed using the air-water system in a 120 mm I.D. bubble column with, and without internals, by varying the percent cross-sectional area covered by the internals. A non-invasive Radioactive Particle Tracking (RPT) method has been employed for estimating the hydrodynamic parameters and mixing characteristics have also been investigated using residence time distribution (RTD) studies with radiotracers. The experimental results obtained in this work indicates that the configuration of the heat exchanger internals, superficial gas, and liquid velocities have a strong effect on liquid phase hydrodynamics and mixing characteristics. (C) 2017 Elsevier Ltd. All rights reserved.