Electrostatic charge generation is a multivariable and complex issue whose working mechanism has never been fully understood. The objective of this paper is to investigate the effect of granule surface roughness on electrostatic charge generation. Two kinds of granule material, Polyvinyl chloride (PVC) and polypropylene (PP) were used with the granule size of 4 mm diameter, 2 mm height and the shape was cylinder or semi-cylinder. The working surfaces were grounded and roughness ranged from 0.140 to 8.600 mu m. It was found that uneven surfaces tended to give rise to voids between two solids, where air stored in the voids was able to accelerate discharging. With the same roughness, PVC tended to generate more electrostatic charge than PP by one order of magnitude. For both materials, electrostatic charge generation first increased with surface roughness and then decreased. The maximum electrostatic charge generated was found to occur when the effects of interaction, contact area and voids discharging were at equilibrium. With the combined effect of humidity, surface roughness and contact area, highest electrostatics generation occurred near the mid-roughness tested in this work. Humidity had more effect on electrostatic charge generation as the granule working surface had lower roughness. (C) 2017 The Society of Powder Technology Japan. Published by Elsevier B.V. and The Society of Powder Technology Japan. All rights reserved.