An experimental investigation has been carried out to study flow and heat transfer in solar air heater for inline holes inserted between absorber and back plate. The analysis has been carried out for cross flow conditions. The effect of flow and geometrical parameters, especially jet diameter and hydraulic diameter has been studied. Mass flow rate for the study is varied corresponding to the Reynolds number range of 4600-12,000. The jet diameter, streamwise pitch, and spanwise pitch, each normalized by hydraulic diameter, i.e. D-j/D-h, X/D-h, and Y/D-h, are in the range: 0.053-0.084, 0.53-0.63, and 0.53-0.63 respectively. Performance is studied in terms of Temperature Rise Parameter (TRP), collector efficiency, and Nusselt number. Hourly variations of solar intensity have also been shown. Collector efficiency increases and Temperature Rise Parameter decreases with increase in mass flow rate for all geometrical configurations. All the above-listed performance parameters are found to be maximum at jet diameter to hydraulic diameter ratio of 0.07. A correlation for Nusselt number in terms of Reynolds number, jet diameter, and hydraulic diameter has also been developed. (C) 2017 Elsevier Ltd. All rights reserved.