Surface functionalization by means of controlled deposition of charged polymers or nanoparticles using the layer-by-layer (LbL) approach has been used to modify mostly engineered materials with welldefined surface chemistry and morphology. In this regard, natural and inhomogeneous interfaces have gained very little attention. Furthermore, natural substrates are susceptible to alterations by factors commonly used to control the growth of multilayers, such as pH, temperature and ionic strength. Here, we study the impact of sorption kinetics of a bilayer system (Poly(diallyldimethylammonium chloride) (PDDA) and Poly(sodium 4-styrenesulfonate) (PSS)) on a natural heterogeneous wood surface at neutral pH, without salt addition, on the multilayer buildup. To overcome analytical limitations we introduce a complementary approach based on UV reflectance spectroscopy, atomic force microscopy (AFM) and zeta potential measurements. Compared to immersion times used for ideal substrates, we found that a high surface coverage requires relatively long immersion, approximately 30 min, into polyelectrolyte solutions, while a sufficient removal of polyelectrolyte excess during the washing step, requires even longer, about 100 min. Based on these findings, we show that film growth can be controlled kinetically. Long immersion times provide well-defined and regular multilayers. The obtained data points to specific requirements to be considered when LbL treatments are applied to rough, porous and heterogeneous surfaces, and thereby sets a basis for a successful transfer of various surface functionalization approaches already shown on ideal surfaces. (C) 2017 Elsevier Inc. All rights reserved.