Indirect resin composites used in indirect restorations have been used as alternative methods to avoid the negative effects of a direct application. The composition and structure of these are similar to a direct composite. Several authors have discussed the elution monomer from resin composites because it is a crucial factor in optimizing the physical properties and biocompatibility of resin composites. The aim of this study was to compare the elution of monomers from different resin composites using high-performance liquid chromatography (HPLC). Indirect composites including Signum, Gradia, and Solidex, and direct composite Filtek Ultimate were used. The samples (2 x 5 mm) were prepared and polymerized for 20 seconds with a light-emitting diode unit. A secondary curing was then applied to the indirect resin composites. After fabrication, each sample was immediately immersed in a 75 wt% ethanol/water solution and analyzed by HPLC. The obtained data were analyzed with one-way ANOVA and Tukey HSD (p < 0.05). Residual monomers were eluted from indirect and direct resin composites and the amount of eluted monomers increased over time. The highest mean concentrations of residual Bis-GMA, UDMA, TEGDMA, and HEMA were detected with the Filtek Ultimate (2,342 mu M), Solidex (7,908 mu M), Signum (2.8 mu M), and Filtek Ultimate (9.7 mu M), respectively. The highest amount of eluted monomer concentrations detected was viewed as critical for toxic reactions in human cells.