Thin films of near-infrared (NIR)-transparent and highly conductive Mo-doped In2O3 (IMO) were prepared as transparent electrodes in thin-film photovoltaic cells and energy-efficient windows. The fabrication process was rapidly optimized by the combined use of atmospheric-pressure mist chemical-vapor deposition (mist-CVD) and sputtering. Mist-CVD was used to rapidly deposit IMO thin films with various Mo-dopant concentrations. We obtained highly conductive IMO thin films with transmittance above 70% in a wide wavelength range of 0.3-2.5 mu m when the Mo-dopant concentration was similar to 1 at% and the Mo dopants had an oxidation state of +4. The IMO films with the optimum Mo-dopant concentration of similar to 1 at% had low resistivities of (3-4) x 10(-4) ohm cm resulting from high electron mobilities exceeding 80 cm(2) V-1 s(-1) and suppressed electron densities of (2-3) x 10(-4) cm(-3), which prevented the degradation of transparency in the NIR region. We applied these findings to the growth of IMO thin films by sputter deposition, which is readily extendable from laboratory scale to industrial scale. As a result, a high-performance IMO film was successfully obtained in only a few deposition runs. The optimized sputtered IMO film exhibited an extraordinarily high electron mobility of 93 cm(2) V-1 s(-1) and relatively low electron density of 1.5 x 10(20) cm(-3), leading to a plasma wavelength that was longer than 4 mu m. This optimized IMO film allowed passage of the full solar spectrum and exclusively reflected far-infrared light corresponding to thermal radiation at room temperature, allowing it to be used as transparent electrodes in photovoltaic cells and heat-reflective electrodes in energy-efficient electrochromic windows. We believe the combination of mist-CVD and sputtering can be extended to rapid optimization of other functional oxide systems. (C) 2017 Elsevier B.V. All rights reserved.