Indoor light control using thermotropic materials is an active area of research. While active materials are available to switch transmittance with temperature, large area heaters with desired transparency are not easily affordable. In this paper, the fabrication of thermochromic devices using inexpensive sn mesh electrodes (5 Omega/, transmission, 80%) produced by crackle lithography with hydroxypropyl methyl cellulose (HPMC) as active material is reported. When laminated and coated on the inner surface of a PET window (8 Chi 8 cm(2)), the mesh served as a transparent heater to cause gelation in HPMC at similar to 40 degrees C to switch from water-clear transparency to paper-white opaqueness with 1 mm thickness of the active layer. The power consumption was only 0.2 W/cm(2). Few drops of a color ink produced interesting effects in this smart window prototype.