An investigation of the morphology of lithium-cobalt-oxide (LCO) films for the production of energy dense, solid-state, thin-film batteries with cathodes in the 10 mu m thickness range is described. It was found that, in order to achieve devices with over 80% charge utilization, capable of extended cycling, with cathodes greater than 5 mu m, LCO film texture must be actively controlled to maintain orientations preferential to Li diffusion. It was found that the oxygen: argon ratio during sputtering of the cathode plays a critical role in determining the crystallographic texture of LCO films thicker than 5 gm. Specifically, LCO films deposited with an oxygen presence of as little as 4% in Ar showed no detectable (003) peak following anneal. Working cells were fabricated using texture-controlled 10 gm cathodes, exhibiting discharge capacities of 60 pAh/cm(2)-mu m (600 mu Ah/cm(2)) at C/10, with greater than 95% capacity retention after 100 cycles at a C/5 discharge rate. Cells with 10 mu m cathodes and un-controlled (predominantly (003)) texture were capable of achieving similar capacities, however their rate and cycling performance were severely diminished. (C) 2017 Elsevier B.V. All rights reserved.