Carbonaceous materials have been proven to have a high catalytic activity for tar removal from the syngas produced from biomass gasification. The simultaneous reforming and gasification of pyrolysis gases and char could have a significant role in increasing the gas yield and decreasing the tar in the product syngas. This study investigates the use of tyre char as a catalyst for H-2-rich syngas production and tar reduction during the pyrolysis-reforming of biomass using a two stage fixed bed reactor. The biomass sample was pyrolysed under nitrogen at a pyrolysis temperature of 500 degrees C, the evolved pyrolysis volatiles were passed to a second stage with steam and the gases were reformed in the presence of tyre char as catalyst. The influence of catalyst bed temperature, steam to biomass ratio, reaction time and tyre ash metals were investigated. The influence of the catalytic activity of tyre ash minerals on composition of syngas and tar decomposition during the steam reforming of biomass was significant as the removal of minerals led to a decrease in the H-2 yield. Raising the steam injection rate and reforming temperature resulted in an increase in H-2 production as steam reforming and char gasification reactions were enhanced. The maximum H-2 content in the product syngas of 56 vol.% was obtained at a reforming temperature of 900 degrees C and with a steam to biomass mass ratio of 6 (g/g). Further investigation Of the influence of the biomass:steam ratio on syngas quality showed that the H2:CO molar ratio was increased from 1.8 (steam: biomass ratio; 1.82 g g(-1)) to 3 (steam: biomass ratio; 6 g g(-1)). (C) 2017 Elsevier Ltd. All rights reserved.