Understanding and manipulating the one half-reaction of photo induced hole-oxidation to oxygen are of fundamental importance to design and develop an efficient water-splitting process. To date, extensive studies on oxygen evolution from water splitting have focused on-visible-light harvesting. However, capturing low-energy photons for oxygen evolution, such as near-infrared (NIR) light, is challenging and not well-understood. This report presents new insights into photocatalytic water oxidation using visible and NIR light. WO2-WO3 hybrid nanorods were in situ fabricated using a wet-chemistry route. The presence of metallic WO2 strengthens light absorption and promotes the charge-carrier separation of WO3. The efficiency of the oxygen evolution reaction over noble metal-free WO2-WO3 hybrids was found to be significantly promoted. More importantly, NIR light (>= 700 nm) can be effectively trapped to cause the photocatalytic water oxidation reaction. The oxygen evolution rates are even up to around 220 (lambda = 700 nm) and 200 (lambda = 800 nm) mmol g(-1) h(-1). These results demonstrate that the WO2-WO3 material is highly active for water oxidation with low-energy photons and opens new opportunities for multichannel solar energy conversion.