The effect of the bed vessel vibration on the oscillatory behavior of the bed bulk and the bubbles is experimentally studied in the present work by means of Digital Image Analysis (DIA) in a pseudo-2D bed. The bed material was three different powders of Geldart A, B and AFB classifications and was operated in bubbling regime for different superficial gas velocities and vibration amplitudes and frequencies. A tracking methodology was developed in order to follow the oscillatory motion of the bed bulk and each individual bubble in the system. This allowed the analysis of the interaction of the dense phase of the bed with the oscillations of the Nibble diameter, position and velocity. The results indicate that both the center of mass of the bed and the bubble characteristics follow the oscillation of the bed vessel with a similar frequency but with a phase delay. The amplitude and phase delay of the oscillation of the center of mass of the bed are more sensitive to variations of the vibration frequency than to variations of the vibration amplitude of the bed vessel. Both the amplitude and the frequency of the bed vessel vibration have a stronger impact on the bubble behavior of beds filled with small particles. The existence of a phase delay between the oscillations of bubble characteristics in the lower and upper sections of the bed indicates the existence of compression-expansion waves in the dense phase that modify the bubble behavior along the bed despite bubbles are interacting with each other. The presence of compression-expansion waves may shed light onto the different behaviors encountered for the mean bubble behavior in vibrated fluidized beds. (C) 2016 Elsevier B.V. All rights reserved.