Manganese oxide (MnO2) nanodispersed on high surface area carbon was tested as cathode catalyst for direct borohydride fuel cells with an anion conducting membrane. In order to investigate the effects of borohydride crossover, ex-situ experiments toward oxygen reduction reaction were conducted employing rotating disk electrodes in presence of borohydride and thiourea. Although platinum showed superior catalytic properties at ideal conditions, manganese oxide outperformed platinum significantly in presence of borohydride. Direct borohydride fuel cell tests were conducted using Pt/C-based and MnO2/C-based. After one hour of operation at 0.40 V the platinum based membrane electrode assembly lost approx. 30% of its initial peak power density while the non-precious metal MEA showed constant performance. The peak power density of the single test cell with a Pt/C based anode, an anion exchange membrane and a MnO2/C based cathode was 38 mW cm(-2). (C) The Author(s) 2016. Published by ECS. This is an open access article distributed under the terms of the Creative Commons Attribution Non-Commercial No Derivatives 4.0 License (CC BY-NC-ND, http://creativecommons.org/licenses/by-nc-nd/4.0/), which permits non-commercial reuse, distribution, and reproduction in any medium, provided the original work is not changed in any way and is properly cited. For permission for commercial reuse, please email:[email protected]. All rights reserved.